3810 BlowOut Base™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing should occur in the dryer.
Due to its unique properties, 3810 BlowOut Base™ can be modified to produce many varied looks and textures. Modified BlowOut Base™ should only be used in production after thorough testing of the modified product. Always test for wash fastness before beginning a production run.
3810 BlowOut Base™ allows the printer to create unique, assorted textures and looks using a variety of print techniques and ink modifications. From adding color concentrates to BlowOut Base™ or overprinting, under basing or mixing in metallic inks, the potential of BlowOut Base™ is only limited by the user’s creativity. Running the BlowOut Base™ through the dryer at higher than recommended temperatures or longer dwell times will also create a variety of different looks.
3810 BlowOut Base™ is a semi-translucent base and should be mixed with other inks or color concentrates or over-printed with other inks to achieve more opacity on dark fabrics. Properly setting squeegee, flood bar and off-contact will improve print performance of the ink.
It is extremely important that 3810 BlowOut Base™ be prevented from getting too hot in storage. Temperatures above 90°F (32°C) may cause the ink to thicken to a point it may be difficult to use.
Always stir 3810 BlowOut Base™ before using.
Test dryer temperatures and wash test printed product before and during a production run.